PGT Driveway & Pavers Nationwide

PGT Driveway & Pavers: The Sherman Oaks Owner’s Guide

We stock and install PGT-compatible driveway and paver systems in Sherman Oaks, with typical installed replacement costs running $7,000-$18,000 for paver driveways and $3,500-$11,000 for paver patios depending on substrate condition and square footage. Most PGT paver inquiries we handle in Sherman Oaks start the same way: a homeowner notices shifting, pooling, or staining that wasn’t there last season, often after one of our Valley heat cycles or a rare heavy rain. The pavers themselves are usually fine; it’s the bedding layer, edge restraint, or joint sand that has failed, and the fix is specific to how PGT systems are engineered to drain.

Call (213) 221-0788

Which PGT Models This Applies To

PGT doesn’t manufacture pavers directly. They source through Belgard, Techo-Bloc, and select regional quarries, then specify joint patterns, edge profiles, and base depths for their driveway and patio installations. If your home was built or landscaped by PGT between 2005 and 2020, you likely have one of three configurations: a standard 60mm residential paver over 4 inches of class II base, a permeable system with 80mm pavers and open-graded stone, or a porcelain paver on a pedestal system for elevated terraces near the Galleria corridor or the hillside lots off Mulholland.

To identify yours, check for a PGT project stamp on the original contract or look for a 2-inch metal edge restraint pinned every 18 inches. The OEM spec calls for ICPI-certified installers and specific bedding sand gradation; we match that with quality aftermarket equivalents from the same quarries PGT used, documented in our written quote. The compatibility gotcha in Sherman Oaks is pedestal systems: PGT specified different pedestal heights for 20mm versus 30mm porcelain, and mixing them causes the lippage we see on several Ventura Boulevard condo terraces.

Signs Your PGT Driveway & Pavers Is Failing

• Pavers rocking underfoot or sounding hollow. The bedding sand has washed out or compacted unevenly, often from irrigation overspray against the Valley’s hard water deposits. We find this most on north-facing driveways in Sherman Oaks where moisture lingers.
• Visible joint widening or sand loss. Polymeric sand breaks down after 5-8 years in our UV exposure; weeds follow, and the interlock that distributes vehicle load starts to fail.
• Pooling water 30 minutes after sprinklers or rain. Indicates base settlement or a clogged permeable joint. In Sherman Oaks, this accelerates subgrade weakening, especially on the clay-heavy soils near the Los Angeles River floodplain.
• Edge pavers tipping or spreading. The edge restraint has corroded or pulled its spikes; this is the first failure mode we check on any PGT driveway over 10 years old.
• Efflorescence whitening that won’t brush off. Calcium hydroxide migration from wet base material, common after winter rains. It’s cosmetic until it signals saturated bedding, then it becomes structural.

Before

After

Replacement Cost & What’s Included

Our quotes are flat prices with written scope, not estimates that balloon. Under Clause 1 of the Haven Standard, you get the number before anyone picks up a tool. The range above reflects whether we’re relaying existing pavers or starting fresh, whether the base needs full reconstruction (common in Sherman Oaks where original PGT specs sometimes skimped on geotextile), and how we handle the spoils. Every paver job carries our 365-Day Done Right Promise, and we document the base condition with photos before we cover it.

DIY or Call Us?

There’s no high-tension danger in paver work, but there’s a costly mistake we see weekly: homeowners relay pavers without checking base saturation. The bedding looks dry at 2 inches but holds moisture at 6, and six months later the same rocking returns. You can safely check joint depth with a screwdriver, photograph the edge restraint condition, and verify whether your pavers are 60mm or 80mm with a tape measure. What you can’t assess without pulling a test section is whether the base is properly drained for Sherman Oaks soil.

We carry replacement edge restraint, polymeric sand, and matching paver samples on our trucks. For the base evaluation, call (213) 221-0788 and we’ll schedule a free estimate with a written price. Measure twice, write it down, then build it.

FAQs