Quikrete Driveway & Pavers Nationwide

Quikrete Driveway & Pavers: The Sherman Oaks Owner’s Guide

We stock and install Quikrete-compatible driveway and paver systems in Sherman Oaks, with typical installed pricing from $4,500 for a standard concrete driveway up to $18,000 for a full paver installation. Most Quikrete product consultations include same-day availability for patch and repair work, and we carry the common Quikrete mixes and bonding agents on our trucks. Homeowners usually discover the problem when hairline cracks spider across the surface after a rainy winter, or when individual pavers start rocking underfoot because the bedding sand has washed out from beneath them.

Call (213) 221-0788

Which Quikrete Models This Applies To

Quikrete does not manufacture pavers or driveway slabs as finished products. They produce the cementitious materials that contractors and DIYers use to build them: Quikrete Crack Resistant Concrete Mix (No. 1006-80), Quikrete Re-Cap Concrete Resurfacer (No. 1131-47), and Quikrete Polymeric Jointing Sand (No. 1175-56) are the three we encounter most often on Sherman Oaks jobs. The gotcha is series compatibility between old and new material. Quikrete Re-Cap, for instance, bonds to existing concrete but demands a minimum ambient temperature of 50 degrees for 24 hours, which means a November cold snap in the Valley can void the cure if you don’t watch the forecast.

To identify what you’re working with, check the stamped product number on any leftover bags, or measure the existing slab thickness. A standard Quikrete driveway pour runs 4 inches with No. 3 rebar on 18-inch centers. If your existing driveway is thinner, it was likely a homeowner mix that won’t match the compressive strength of a proper Quikrete 4,000 PSI pour. We source OEM Quikrete products through our dealer network and do not substitute off-brand cement mixes, since the cure rate and color match vary enough that a patch becomes obvious by the following spring.

Signs Your Quikrete Driveway & Pavers Is Failing

• Hairline cracking in a map pattern. This is usually plastic shrinkage from too much water in the original mix or rapid surface drying in Sherman Oaks’ summer heat. The cracks widen each freeze-thaw cycle, and water carries dissolved salts from the soil beneath, which effloresces as white powder on the surface.
• Spalling or surface flaking. The top 1/8 to 1/4 inch delaminates, often from de-icing salt use or from finishing the surface while bleed water was still present. Quikrete Re-Cap can restore the surface if the substrate is sound, but only if more than 50 percent of the original surface remains intact.
• Individual pavers settling or rocking. The bedding sand layer beneath has eroded, typically from inadequate edge restraint or from polymeric sand that never fully activated because it was installed before a rain. In the hillside lots off Mulholland Drive, we see this accelerated by minor soil movement that shifts the base course.
• Weeds growing through joints. The jointing sand has washed out completely, leaving voids that collect organic matter. This indicates the original installation either skipped polymeric sand or used a grade too fine for the joint width. Quikrete HardScapes Polymeric Sand comes in three widths for exactly this reason.
• Standing water after light rain. The surface has lost its pitch, either from subgrade settlement or from tree root intrusion. In Sherman Oaks, the mature ficus and camphor trees along older streets lift slabs gradually; the fix is rarely the surface material alone and usually requires addressing the root or regrading the base.

Before

After

Replacement Cost & What’s Included

Here’s what driveway and paver work costs in Sherman Oaks with Quikrete materials:

The range depends on three factors: square footage, whether we need to remove and haul existing material, and access. A driveway on a flat lot near Ventura Boulevard with a side gate for our mini-excavator prices toward the lower end. A hillside property with retaining wall work and no equipment access prices higher because we hand-carry material and compact in lifts with a plate compactor we walk in piece by piece.

Every quote is a flat written price with line-item breakdown. Under Clause 1 of the Haven Standard, that price is delivered before any work starts. Our 365-Day Done Right Promise covers the installation, and we pull all required permits through the City of Los Angeles Bureau of Engineering. No change proceeds without a signed change order, which is the discipline that has kept our projects within a few percent of the agreed cost since 2007.

DIY or Call Us?

There is no dangerous high-tension component in driveway or paver work, but there is a point where DIY becomes expensive do-over. An owner can safely check: measure the crack width with a feeler gauge, photograph the spalling for comparison later, and verify whether water drains within 30 minutes of a hose test. What goes wrong in DIY is the prep. Quikrete Re-Cap fails when applied over a surface that wasn’t pressure-washed and acid-etched, or when applied too thin under 1/8 inch. Paver reset fails when the bedding sand isn’t screeded level and compacted in two lifts, which is why the pavers rock again inside six months.

We carry Quikrete Re-Cap, bonding adhesive, and polymeric sand on our trucks for same-day patch work. For full replacement, we schedule a site visit, deliver a written price within 24 hours, and stock the material once you sign. Call (213) 221-0788 to schedule your free estimate.

FAQs