Boral Windows & Doors Nationwide

Boral Windows & Doors: The Sherman Oaks Owner’s Guide

We stock and install Boral-compatible windows and doors across Sherman Oaks, with typical replacement projects running $4,500-$15,000 for window replacement and $8,000-$25,000 for impact-rated installations. Most Boral hardware, weatherstripping, and operator parts are on our trucks or available next-day through our distributor network. Homeowners usually discover a problem when a window won’t stay open, a door drags on the jamb, or they feel a draft along the sill despite the latch appearing closed.

Call (213) 221-0788

Which Boral Models This Applies To

Boral’s window and door catalog spans several series, and the part you need depends on when your unit was manufactured. Pre-2018 Boral vinyl windows often used Truth EntryGard operators with a 9/32-inch spindle; post-2018 production shifted to Roto hardware with a 3/8-inch spindle, and the two are not interchangeable without modifying the sash mortise. Boral’s aluminum-clad wood line, common in the Ventura Boulevard corridor renovations we see, typically uses Hoppe multipoint locking systems with a 92mm or 102mm backset. The label is usually found on the sash edge or the hinge side of the door frame; if it’s worn off, measure the spindle diameter and the backset from the edge of the door to the center of the keyhole. We’re an independent service provider, not affiliated with Boral, so we source both OEM Boral parts and quality aftermarket equivalents from AmesburyTruth and Roto Frank. OEM guarantees color match and exact fit; aftermarket often saves 20-30% on hardware and performs identically for mechanical components like balances and rollers.

Signs Your Boral Windows & Doors Is Failing

• Window slams shut or won’t stay open. The coil balance or constant-force spring has lost tension. In Sherman Oaks, we see this accelerated by the dry Santa Ana cycles, which degrade the nylon bushing faster than in coastal zones.
• Door sticks or drags at the threshold. The sill cap or adjustable threshold has compressed or the hinges have settled. On Boral’s outswing patio doors, the hinge pin often wears eccentrically after five to seven years of use.
• Visible daylight around the frame. The compression weatherstrip has hardened or the bulb seal has torn at the corners. Boral’s Q-Lon foam-filled gasket, while durable, will take a permanent set if compressed for years in the locked position.
• Condensation between glass panes. The insulating glass unit (IGU) seal has failed, allowing moist Valley air between the lites. This is not repairable; the IGU must be replaced or the entire sash swapped.
• Lock tongue doesn’t fully engage. The multipoint mechanism has slipped out of alignment or the keeper has shifted with seasonal frame movement. A misaligned lock stresses the handle and will eventually snap the spindle.

Before

After

Replacement Cost & What’s Included

For Boral window replacement in Sherman Oaks, we quote $4,500-$15,000 depending on count, access difficulty, and whether we’re matching existing trim or replacing it. Impact window installation runs $8,000-$25,000. Hardware-only repairs, operator replacements, or weatherstripping swaps typically fall in the $300-$800 range per opening. Our quotes include parts, labor, disposal of the old unit, and a written warranty. Under Clause 1 of The Haven Standard, you receive that written price before any work starts. No change proceeds without a signed change order, which is why our projects finish within a few percent of the agreed number. We pull permits when required by Los Angeles Building Code and schedule inspections as part of the scope.

DIY or Call Us?

An owner can safely check whether the lock engages fully, whether debris blocks the weep holes at the sill, and whether the weatherstrip is visibly torn. These checks cost nothing and sometimes solve the symptom. Where DIY goes wrong is in removing a sash with failed balances, adjusting multipoint hardware without knowing the sequence, or attempting to reglaze an IGU. The spring tension in a constant-force balance can release suddenly, and a dropped sash in a second-story Sherman Oaks opening is a hazard to whoever is below. We carry Boral-compatible operators, balances, locks, and weatherstrip on our trucks, and our background-checked, uniformed technicians arrive with a documented photo record as standard. Measure twice, write it down, then build it. For anything involving glass removal or spring hardware, call (213) 221-0788 to schedule your free estimate.

FAQs