Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
ES Windows Driveway & Pavers: The Sherman Oaks Owner’s Guide
We stock and install ES Windows-compatible driveway and paver systems in Sherman Oaks, with typical installed pricing running $7,000-$18,000 for paver driveways and $3,500-$11,000 for paver patios depending on substrate condition and square footage. Most ES Windows-related paver calls we see in Sherman Oaks involve settling along the Galleria corridor, where the clay-heavy soil shifts with winter rains and summer dry spells. The homeowner usually notices it first as a wobble underfoot or water pooling where it used to drain.
Which ES Windows Models This Applies To
ES Windows doesn’t manufacture pavers directly; they source through regional partners, and the systems we match in Sherman Oaks typically carry the ES-PD (Paver Drive) or ES-PT (Paver Terrace) designation on the original installation paperwork. If you don’t have that paperwork, check the edge restraint profile - ES Windows systems use a 60mm-thick concrete paver with a chamfered edge and a specific 3/16-inch joint spacing that differs from Belgard or Techo-Bloc standard spacing by a hair. Measure twice, write it down, then build it.
We carry both OEM-equivalent pavers from ES Windows’s current supplier and quality aftermarket matches from Belgard and Techo-Bloc that meet the same ASTM C936 spec for interlocking concrete pavers. The aftermarket route saves roughly 15-20% on material cost without changing the structural performance, and we note the source on every written quote so you know what you’re getting.
Signs Your ES Windows Driveway & Pavers Is Failing

- Sunken or tilted pavers near downspouts or irrigation lines. In Sherman Oaks, the combination of clay soil and mature root systems from the ficus and camphor trees common along Ventura Boulevard corridors creates exactly this pattern. Water finds the gap, soil migrates, and the paver loses its bedding layer.
- Joint sand washing out repeatedly after rain. This usually means the edge restraint has pulled away or the bedding sand underneath has eroded. Without that locked edge, the joint sand has nowhere to stay put.
- Efflorescence - white powder rising to the paver surface. It’s calcium carbonate from the concrete itself, accelerated by the low overnight humidity and rapid morning heating typical of Sherman Oaks summers. Not structurally dangerous, but it signals moisture is moving through the system in ways the original install didn’t anticipate.
- Pavers rocking underfoot or making a clicking sound when walked on. The bedding layer has compacted unevenly, often because the original base was installed at insufficient depth for the traffic load. RV parking pads are especially prone to this in the hillside neighborhoods north of Mulholland.
- Standing water 24 hours after rain. The pitch has reversed, usually from substrate settlement. In Sherman Oaks, this is a code-adjacent concern - standing water against a foundation can trigger drainage corrections if reported during a sale inspection.
Before
AfterReplacement Cost & What’s Included
| Scope | Price Range in Sherman Oaks |
|---|---|
| Paver driveway installation (new) | $7,000 - $18,000 |
| Concrete driveway installation | $4,500 - $12,000 |
| Driveway replacement (remove + replace) | $5,000 - $14,000 |
| Paver patio installation | $3,500 - $11,000 |
| Driveway sealing | $250 - $700 |
| Spot repair / re-leveling (per section) | $800 - $2,500 |
The range depends on three things: how much of the base needs to be excavated and recompacted, whether we hit irrigation or drainage lines that need rerouting, and the paver grade you select. Under Clause 1 of The Haven Standard, the price we write is the price you pay - every line item is listed before work starts, and no change proceeds without a signed change order. The 365-Day Done Right Promise covers the installation, and we pull all required permits and pass inspections as standard, not as an add-on.
DIY or Call Us?

A homeowner can safely check a few things: verify whether the issue is isolated to one area or spreading, photograph the pattern for documentation, and confirm whether water is reaching the foundation. What doesn’t work as DIY is base excavation and recompaction - the plate compactor rental won’t save you if the subgrade isn’t tested for proper density, and in Sherman Oaks the clay content means standard bedding sand specifications often need adjustment. We’ve seen well-intentioned homeowners in the Magnolia Park area spend weekends re-laying pavers that settle again in six months because the base wasn’t addressed. For a documented assessment and written price, call (213) 221-0788.
FAQs
Properly installed concrete pavers last 25-30 years in this climate, though the joint sand and sealant need refresh every 3-5 years. The thermal cycling in Sherman Oaks - 50-degree swings between summer days and desert-cooled nights - accelerates surface wear slightly compared to coastal zones. Call (213) 221-0788 for an exact quote - estimates are free.
Yes, if the base is still sound. We lift the affected pavers, regrade and recompact the bedding layer, and relay them with fresh joint sand. This runs $800-$2,500 depending on area size, versus $5,000-$14,000 for full replacement. The key is catching it before water has undermined the edge restraint or the subbase. Call (213) 221-0788 for an exact quote - estimates are free.
Most residential driveways in Sherman Oaks take 3-5 working days from excavation to final compaction, assuming no utility conflicts. Permits add 2-3 days to the front end, which we handle and include in our project timeline. Weather delays are rare here but we build a buffer into every schedule we write. Call (213) 221-0788 for an exact quote - estimates are free.
We don’t stock pavers on the truck - they’re color-matched and ordered to spec - but we maintain supplier relationships with ES Windows’s regional distributor and with Belgard and Techo-Bloc, which means typical lead time is 3-5 business days for standard colors and profiles. Rush orders are possible for common earth-tone blends. Call (213) 221-0788 for an exact quote - estimates are free.
Rowan Construction Group Sherman Oaks is an independent service provider and is not affiliated with ES Windows. We also stock and install parts for KraftMaid, Cambria, and Silestone systems.
Written by Grant Rowan, Owner, Rowan Construction Group Sherman Oaks at Rowan Construction Group Sherman Oaks, serving Sherman Oaks and nearby areas.







Before
After
Before
After
Before
After